Features P16 P32 P64
Alarm system concept Hybrid modular system Hybrid modular system Hybrid modular system
On-board wired zones 7/14 (doubling)

7/14 (doubling)

7/14 (doubling)
2-wire smoke detector input 1 1 1
On-board wireless zones 16 32 64
Maximum zones in system 16 32 64
On-board PGM 3 3 3
Maximum PGM in system 16 16 16
User + installer codes 31+1 31+1 63+1
Duress code

X1, X2, X3, X4 (when X4 = X4 + 1)

Defaulting user code Yes Yes Yes
Key switch zone Yes Yes Yes
Partitions 4 4 4
"Shared" partition (common area) Yes Yes Yes
System timers 16 16 16
Maximum keypads/modules in system 15 15 15
Keypad compatibility All SECOLINK keypads All SECOLINK keypads Only KM24G, KM25
Event log buffer 512 512 512
PSTN communicator Plug-on Plug-on Plug-on
In-built interface for backup communicator TTL Serial TTL Serial TTL Serial
Data bus protocol KRBUS KRBUS KRBUS
Total phone numbers: CMS reporting + personal dialing 9 9 9
Maximum phone numbers for personal dialing Up to 5 Up to 5 Up to 5
Maximum phone numbers for CMS reporting Up to 4 Up to 4 Up to 4
Reporting protocol Contact ID Contact ID Contact ID
Voice guide for system control over PSTN Yes Yes Yes
Voice guide for system programming over PSTN Yes Yes Yes
"Roller" detector type Yes Yes Yes
"Vibration" detector type Yes Yes Yes
"Vibration" zone speed (sensitivity) 0.01 - 0.25 sec. 0.01 - 0.25 sec. 0.01 - 0.25 sec.
Normal zone speed (sensitivity) 0.1 - 2.5 sec. 0.1 - 2.5 sec. 0.1 - 2.5 sec.
Zone loop (detector) type NC, NO, NC/EOL, NO/EOL, NC/DEOL, NO/DEOL, Vibration, Roller
Arming mode Away, Max Away, Night, Stay.
Zone definition

Entry/exit, entry/exit forced, interior, interior night armed, follower, follower night armed, perimeter, instant, PGM control;

24h: burglary, panic silent, panic audible, tamper, fire, smoke, fire button, medical button, fire supervisory, low water level, RF Jam, gas detected, water leakage, high temperature, low temperature

Zone attributes Enable bypass, no alarm, arm when door is closed, entry route, exit route, fire verification, limitation of alarms, limitation of reporting, pre-alarm, armed night
PGM definition Fire alarm, fire/burglary alarm, burglary alarm, tamper alarm, technical alarm, selected alarms, chime, zone violation, bypass status, selected trouble, exit/entry warning, exit/arm status, full arm status, power supply, resettable power supply, fire power supply, timer, mono/bi switch
PGM attributes Inversion, pulsation, latch, pre-alarm, arm notification, arming failure notification, disarm notification, clear alarm notification, armed in specific mode
Rated voltage of power supply (AC) ~20 V ~20 V ~20 V

Minimum AC voltage

(note: ~16 V input voltage lets control panel to generate max 0.7 A output current)

~16 V ~16 V ~16 V

Maximum AC voltage

(Note: higher than ~22 V voltage can damage control panel)

~22 V ~22 V ~22 V

Maximum long term output current of control panel

(I+AUX + I+BELL + I+PGM + battery charge):

≤1.5 A ≤2.0 A ≤2.0 A
Maximum current of slow blowing fuse used in primary AC 250 mA 250 mA 250 mA
Maximum AC power consumption 150 mA 150 mA 150 mA
Minimum voltage on +AUX, +BELL, +PGM outputs 12 V 12 V 12 V
Maximum voltage on +AUX, +BELL, +PGM outputs 13.9 V 13.9 V 13.9 V
Maximum current out of +AUX +1 A +1 A +1 A
Maximum current out of +BELL +2 A +2 A +2 A
Maximum current into -PGM -0.3 A -0.3 A -0.3 A
Maximum current out of +PGM +0.5 A +0.9 A +0.9 A
Short circuit, overload protection of +BELL, +PGM, +AUX Electronic Electronic Electronic
Battery charge, +BELL, +AUX current measurement Yes Yes Yes
Failed (waste) backup battery disconnection Yes Yes Yes
Maximum battery charging current 0.35 A 0.35 A 0.35 A
Maximum current of fast blowing fuse used in battery circuit 3.15 A 3.15 A 3.15 A
Control panel disconnect battery when it’s voltage less than 9.5 V 9.5 V 9.5 V
Recommended backup battery 12 V, 7 Ah / 20 Hr 12 V, 7 Ah / 20 Hr 12 V, 7 Ah / 20 Hr
Operational compliance EN50131, Grade2 EN50131, Grade2 EN50131, Grade2
Overall dimensions W x H in mm 145 x 77 145 x 77 145 x 77
Environmental compliance ROHS ROHS ROHS
Operating temperature -10oC up to +50oC
Production status

In production

In production

In production
Interface with PC

USB mini-B

USB mini-B

USB mini-B
Latest firmware version



Wiring manual Download
Programming manual (for KM20B keypad) Download
Programming manual (for KM24x, KM25 keypads) Download